Why is my washer stuck on sensing Maytag?
If your Maytag washer’s sensing light is stuck and will not move to the appropriate cycles, this is usually caused by a stuck or keypad. The keypad can occasionally become jammed or, if you have recently replaced a part on the washer, you may have forgotten to recycle the codes, which can lead to a stuck sensor light.
Why is my washer staying on sensing?
When Kenmore HE Washer is stuck on Sensing Cycle and not proceed to the Wash cycle, most likely one of these 3 parts malfunction: Failed Water Inlet Valve or Inlet Valve Tap is in OFF position. Shift Actuator not able to change position, before Wash cycle. Control Board malfunctioned.
What to do if washer is stuck on sensing?
You may unplug and plug in the washer and turn the power on. Lift and close the lid about six times within 12 seconds to reset the unit. You can also reset your washer by checking your product manual. Start a new wash cycle and test the appliance.
Why is the sensing fill light flashing?
Done right ASAP-If the “sensing /fill” is the only light on and it’s flashing then the cycle has paused. Push the PAUSE button once and the light should be on but not flashing and the cycle should continue within about 10 min depending on water pressure. You could have a slow fill. Unplug unit.
How long should washer be on sensing?
These sensing spins may take 2 to 3 minutes before water is added to the load. The washer will then move the load briefly, pause to allow water to soak into the load, and resume adding water. This process may repeat until the correct amount of water has been added to the load.
Why is my washer not filling up with water?
If your washer if not filling, start by making sure the faucet at the water-supply end of the hose is turned on. If you have un-kinked hoses that are tightly attached and with clean screens, and you have good water pressure, the next place to check for a water-filling problem is the water inlet valve.
How do you reset a washing machine sensor?
To reset your washing machine, unplug it from the power outlet. Then, plug the washer cord back into the wall. Finally, open and close the washing machine door six times to send the reset signal to the system components.