Why is my Sharp Aquos TV power light blinking?
Any blinking activity on the Sharp TV OPC (Optical Picture Control) light most likely indicates an error. When the light is constantly blinking, you must troubleshoot to narrow down the problem and seek solutions. Problems can arise from hardware issues or the firmware installed on the television.
How do you fix a blinking green light on a Sharp TV?
Unplug set, press and hold (on set) volume-down and channel-down and hold them while pluging in set. Will come on with “k” on screen, or will crash again if backlight bad. If it stays on, use your remote and arrow right then look for “fact init” and any other reset and turn them on.
Why is my Sharp Aquos TV not turning on?
Make sure the AC cord is not loose or disconnected. Check to ensure the cord is firmly plugged into the outlet at one end, and firmly connected to your television at the other end. Try powering up the TV with the cords firmly connected.
How do you reset a Sharp TV that wont turn on?
For a hard reset:
- Unplug your TV.
- Press and hold the “Channel Down” and input” buttons on the panel.
- Plug the TV back while holding down these buttons.
- Keep holding the buttons until the TV powers back on.
- Use the remote to navigate the “Service Mode” menu and select “Factory Reset” from the menu.
What does it mean when Sharp TV flashes?
If it’s still flashing, power cycle your TV: unplug it at the electrical socket on your surge protector or wall, wait two minutes and then plug it in again. Go to the Sharp Product Downloads page and look for a firmware update for your Sharp Aquos TV’s if the flashing continues.
How do I reset my Sharp Aquos TV without a remote?
How To Reset Sharp Tv Without Remote [Hard Reset]
- Unplug the television.
- Press and hold the “Channel Down” and “Input” buttons on the panel.
- Plug the television back in while holding down these buttons.
- Keep holding the buttons until the television powers back on.
How to reset the screen on a sharp TV?
How to Reset Your Sharp LCD TV | TV Repair 1 Remove main power source from the TV for 15 Seconds 2 Press Volume Up and Channel Up on your TV. 3 While pressing put the power cable back on. 4 Keep holding it until you see the reset screen
Why does my Sharp Aquos TV not turn on?
A blown fuse or defective main power transistor in the power supply can cause a Sharp Aquos TV to not power on when the standby light is blinking. In addition, a faulty inverter, worn-out release button or failure to reset a Sharp Aquos TV can result in a blinking green light when the TV is turned on.
How to troubleshoot sharp TV with the OPC light flashing?
Simultaneously press and hold the “input” and “channel down” buttons on the remote. Plug the TV back into power and wait for the television start while you hold down these buttons. Select “Service Mode” from the menu and then select “Factory Reset” to restore the original settings.
What to do when power button flashes on sharp TV?
Will come on with “k” on screen, or will crash again if backlight bad. If it stays on, use your remote and arrow right then look for “fact init” and any other reset and turn them on. Arrow back up to “fact init” and hit enter. Let set recycle to green and unplug/re-plug in 5 seconds: the set should be in OOB state. Click to expand…