Where is the locking mechanism in a car door?
On the interior of a car door, the door-lock actuator is the mechanism that controls the door lock. The actuator is located directly below the key latch. A thin metal rod goes between the actuator and the key latch and connects the two.
How does a door lock mechanism work?
When it is locked, a series of spring-loaded pins are engaged by the cylinder. This keeps the cylinder from turning. The Bolt: Also called the latch, the bolt engages the inside of the door. There is a piece of metal that extends from the door into the frame itself.
How do you lock a Mini Cooper key?
Tap the lock button three times and within 10 seconds. Release both buttons and you will find your MINI Cooper doors will lock/unlock.
How do you reset a Mini Cooper key fob?
Right after turning the key back and forth four times, remove the key from the ignition, then hold the unlock button on the remote and press the lock button. With the unlock button pressed down, let go of the lock button then press it for a total of three times; on the third time, release both buttons at the same time.
How can I Fix my Mini Cooper door lock?
Snug the screws down, but not fully tight – just enough to hold it still in place. Remount the interior handle and its cable to the door frame. Thread the manual lock push rod back through the grommet and insert the end into its clip in the actuator. You should be ready to manually test the lock to be sure the cables are functioning.
How to replace the lock actuator on a Mini Cooper?
Take off the cable from the door panel clips in order to put the cable into the door panel. Push the cable through the door panel hole, which was blocked by the rubber before. In order to remove the lock actuator with ease, the guide rail for the window nearest the actuator must be moved.
Where is the lock reflector on a Mini Cooper?
The fourth is hidden behind the small clear/white reflector slightly below the lock button at the back of the door. Use the small blade screw driver to carefully pry up the reflector to remove it from the door and put it aside (where it won’t get lost or damaged, so you can re-install it later).
Where are the screws on a Mini Cooper door panel?
The door panel is held in place by 4 torx screws (either #20 or #30) and a series of clips around the perimeter. Three of the torx screws are in obvious locations: the recesses in the panel.