How much torque do you put on transmission pan bolts?
Setting the pan bolts to 12 foot-pounds of torque is only recommended after the pan is properly inspected and repaired.
How tight should I tighten my transmission pan bolts?
Pan bolts should be 8mm, probably 20mm long. Start the two rear bolts by hand using your socket. Do not run the bolts up too tight.
Do you need a torque wrench for transmission pan?
Proper transmission service requires us to remove the pan on those transmissions that have them. We should always tighten transmission pan bolts to the specified torque, when we install them. This is done with a torque wrench. If we use this method, the torque on the bolts are correct.
How many quarts does a th350 transmission hold?
The pan holds 2.5 to 3 quarts only. Don’t run it too long with very little fluid in it or out it comes again.
What kind of transmission fluid does a 4R70W take?
The 4R70W and many other Ford transmissions require MERCON V automatic transmission fluid.
Can transmission bolts come loose?
Loose bolts and drain plugs are the most common cause of transmission fluid leakage. The transmission pan is removed and the transmission fluid drained and replaced during a transmission flush. When the flush is over, incompetent auto mechanics sometimes forget to properly tighten bolts and drain plugs.
How many bolts are in a transmission pan?
16 or 17 bolts for Trans. pan.
What size are transmission pan bolts?
Automatic Transmission Oil Pan Bolt by Genuine®. Size: 6 mm x 28.5 mm.
How much fluid does a TH350 torque converter hold?
| Transmission Fluid Capacity | |
|---|---|
| Transmission (w/ Stock Pan) | # of Quarts |
| GM TH350 | 4 |
| GM TH400 | 6 |
| GM Powerglide | 4 |
How long is a 350 Turbo transmission dipstick?
Turbo 350 Automatic Transmission Dip Stick, 26.5 Inch Length.
How much torque does a TH350 transmission pan have?
I use ‘Gasgacinch’ for glueing the gasket to the pan and nothing between the gasket and trans. TH350 pan bolt torque is @8ft lbs.
How many quarts does a Turbo 350 transmission take?
The TH350 takes about 4 quarts in the pan, and then requires additional based on the torque converter being used. When combined with a 9.5” converter, the overall requirement is around 10 quarts. The Turbo 350 transmission, commonly known as the TH350, was a 3 speed automatic transmission that began phasing out the GM Powerglide in 1969.
What are the specs for a Turbo 350?
Turbo 350 Performance Specs. The most torque from an engine that this transmission was applied to was 410 lb-ft. This is an automatic transmission that is longitudinally mounted, making it applicable for rear-wheel drive cars. This transmission is a 3 speed, and no overdrive gear was available.
What are the gear ratios on a TH350?
This transmission is a 3 speed, and no overdrive gear was available. The gear ratios used for this transmission were 2.52 for 1st gear, 1.52 for 2nd gear, and 1.0 for 3rd gear. The Turbo 350 transmission was a single piece transmission with the bell housing integrated into the transmission body.