Can you change a stereo recording to mono?
1) Click the down arrow on the track to open the menu. 2) In the menu that drops down, select Split Stereo to Mono. 3) Click X to delete one of the two tracks. 4) To save the new mono audio file, click File.
How do you split audio in Digital Performer?
Both of these can be done quickly in Digital Performer. Open the Waveform Editor in DP, and use the drop-down menu on the top right to select your stereo soundbite. Hold down the Command/Ctrl Key and make a selection in time over the left or right track.
How do you convert a stereo track to mono in Cubase?
Converting a Selection From Stereo to Mono
- Make a stereo selection in the wave window.
- Select File > New.
- Select Audio File > From Current File.
- Select one of the following options: To mix the left and right stereo channels when converting to mono, click Mono Mixdown.
Can I use stereo cable for mono?
You can without any concerns plug a stereo cable into an unbalanced mono jack; as long as you only send mono signals (i.e. L and R channels equal) it will work just fine, except for the usually -3 dB pan law and possible short-cicuiting of the ring connector; the latter is however unlikely and not harmful for line …
How do I convert mono to stereo online?
CoolUtils is another online audio converter that allows you to convert mono to stereo online in MP3, WMA, WAV, OGG, and MP4 formats. You can change the file’s properties to pick between mono and stereo, as well as the sample rate and bit rate. After the file has been converted, it can be downloaded to your computer.
How do I record mono in Cubase?
If you are using a single source, you need to set up Cubase to record a mono track. To do this, the Stereo switch button in the Inspector allows you to toggle between mono and stereo. The button will be gray and contain 1 circle if the track is set to mono, and be yellow with 2 circles when set to stereo.