How do you adjust the governor on a Honda gcv160?
Adjusting GXV160 Governor
- Loosen the governor arm nut on the governor arm.
- Push the governor arm away from the carburetor, and open the carburetor throttle valve fully.
- Holding the carburetor throttle valve fully open, turn the governor arm shaft clockwise fully, and tighten the governor arm nut.
How does a Honda engine governor work?
To control engine speed, a mechanical governor uses gears and flyweights inside the crankcase to detect changes in the load and adjusts the throttle accordingly. This closes the throttle, limiting the air-fuel released into the engine. When the engine load increases, the crankshaft spins more slowly.
How does the governor work on a pressure washer?
The speed-sensing device on a pneumatic governor is a movable air vane, made of metal or plastic. This small engine part registers the change in air pressure around the spinning flywheel. The pneumatic governor also relies on one or two springs to pull the throttle toward the open position.
What is the valve clearance on a Honda GCV160?
Standard valve clearance: 0.15 ± 0.04 mm (0.006 ± 0.002 in) (IN) 0.20 ± 0.04 mm (0.008 ± 0.002 in) (EX) ⑥. If adjustment is necessary, proceed as follows: a. Hold the adjusting screw using the special tool, and loosen the lock nut. b.
How do you adjust the governor on a generator?
Insert a flat screwdriver into the yellow governor control screw with a spring around the screw threads. This screw is located on the governor linkage. Monitor the tachometer reading during adjustment. Turn the screw counterclockwise to increase engine RPM, and clockwise to reduce engine RPM.
How does speed governor work?
In general, speed governors have electronic sensors and these sensors work with the engine’s computer to be able to control the speed rate of vehicle. The electronic sensors collects data of the speed rate of a vehicle, and conveys that information to the engine’s computer.
What happens if you adjust the Governor of an engine?
In the event that they do need adjusted, here is how to do it. One of the most important parts of your engine is the engine governor. An improperly adjusted governor can shorten your engine’s life. If engine speed is not controlled, the engine will destroy itself.
What kind of engine does a Honda G150 have?
Honda G150 K1. The Honda G150 K1 is a 0.1 L (144 cc, 8.79 cu·in) natural aspirated single-cylinder four-stroke air-cooled internal combustion small gasoline engine with a horizontal shaft, manufactured by Honda Motor Company since 1977 for general-purpose applications.
How do you adjust the governor on a Briggs and Stratton engine?
Tighten the screw and you’re done. To adjust the governor on a Briggs and Stratton horizontal shaft engine, you would loosen the nut on the governor arm and push the governor arm down, clockwise. Then you would turn the governor shaft clockwise also and tighten the nut
How do you adjust the governor on a LEV engine?
For example, on Tecumseh TVS, LEV, TVM, TVXL and other similar engines, the governor arm rocks in the counter clockwise direction to close the throttle to idle. To adjust the governor, you would loosen the screw on the bottom of the governor arm and push the governor arm so the throttle is wide open.